TOSHIBA DVD-ROM SD-R1312 не пишет

Автор: rvn Дата: 05.02.2004 22:51 В linux-e я новичок. И вот сразу проблема....
Стирать у него(subg) получается. А вот запись не идет. Может кто нибудь знает.
Высылаю выход cdrecord-a:
[root@localhost root]# cdrecord -version
Cdrecord 2.01a04 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jцrg Schilling
[root@localhost root]# cdrecord -scanbus
Cdrecord 2.01a04 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jцrg Schilling
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
scsibus0:
0,0,0 0) 'TOSHIBA ' 'DVD-ROM SD-R1312' '1011' Removable CD-ROM
0,1,0 1) *
0,2,0 2) *
0,3,0 3) *
0,4,0 4) *
0,5,0 5) *
0,6,0 6) *
0,7,0 7) *
[root@localhost root]#
[root@localhost iso]# /usr/bin/cdrecord -eject -dev=0,0,0 speed=8 -v backup.iso
Cdrecord 2.01a04 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jцrg Schilling
TOC Type: 1 = CD-ROM
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'TOSHIBA '
Identifikation : 'DVD-ROM SD-R1312'
Revision : '1011'
Device seems to be: Generic mmc2 DVD-ROM.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R96R
Drive buf size : 1791936 = 1749 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 0 MB
Total size: 1 MB (00:06.28) = 471 sectors
Total size: 1 MB (00:06.28) = 471 sectors
Lout start: 1 MB (00:08/21) = 471 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 2
Reference speed: 6
Is not unrestricted
Is erasable
Disk sub type: High speed Rewritable (CAV) media (1)
ATIP start of lead in: -11077 (97:34/23)
ATIP start of lead out: 359849 (79:59/74)
1T speed low: 4 1T speed high: 10
2T speed low: 2 2T speed high: 10
power mult factor: 2 6
recommended erase/write power: 5
A1 values: 24 2C DC
A2 values: 14 A4 4A
A3 values: 04 C4 80
Disk type: Phase change
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 359378
Starting to write CD/DVD at speed 4 in real TAO mode for single session.
Last chance to quit, starting real write 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Turning BURN-Free off
Performing OPC...
Starting new track at sector: 0
Track 01: 0 of 0 MB written.
Track 01: Total bytes read/written: 960512/960512 (469 sectors).
Writing time: 5.683s
Average write speed 1.1x.
Fixating...
/usr/bin/cdrecord: Input/output error. close track/session: scsi sendcmd: no error
CDB: 5B 00 02 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 06 00 00 00 00 0A 00 00 00 00 29 00 00 00
Sense Key: 0x6 Unit Attention, Segment 0
Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 23.978s timeout 480s
cmd finished after 23.978s timeout 480s
Fixating time: 23.979s
/usr/bin/cdrecord: fifo had 16 puts and 16 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
Re: TOSHIBA DVD-ROM SD-R1312 не пишет 14.02.2004 22:38Ugol Доброе веремя суток!
В ALTLinux Master 2.2 / ядро-->2.4.20-alt11
TOSHIBA DVD-ROM SD-R1312 пишет и стирает. Вообщем,
полностью рабочий девайс.
Firmware version 1011
Дмитрий.
Re: TOSHIBA DVD-ROM SD-R1312 не пишет 18.02.2004 21:05МихаилZ Думаю можно обновить cdrecord
У меня был опыт записи на этом RW в последнем Кноппиксе - все в порядке
RSS-материал